Audio Note JINRO Specifications download pdf (Page 13)

OPERATION

Once all the connections are completed and checked, ensure that the volume control

of your preamplifier / source is at the minimum setting.

Turn on all components in the signal chain before the JINRO Shochu; the power

amplifier should always be the LAST component to be switched ON, and the FIRST

to be switched OFF.

Turn on the amplifier by using the rocker switch located at the top right of the rear

panel, just above mains inlet socket (viewing the amplifier form the rear).

Bedding in The new amplifier requires about 200 hours of initial use (called

“bedding in”) before the circuitry becomes stable and optimum

performance is realized.

As the amplifier “bed in” the sound will become increasingly

smoother, detailed and open.

Once the amplifiers have “bedded in” a warm up time of

approximately 30 to 45 minutes is required each time the

amplifiers are switched on before optimum sonic performance

is reached.

Cleaning No special maintenance is required for the amplifier. Use a

soft, clean lint free cloth to remove any surface marks from the

casework. For finger marks / grease, use a soft, clean lint free

cloth, lightly moistened with a solution of warm water and mild

detergent. Do not use any alcohol or solvent based cleaning

products, as they may damage the finish of the amplifiers.

ENSURE THAT THE AMPLIFIER IS SWITCHED OFF AND

DISCONNECTED FROM THE MAINS ELECTRICITY

SUPPLY BEFORE UNDERTAKING ANY CLEANING.

Valve Life The valves supplied with your amplifier should provide

approximately 6000 hours of operation. They are specially

selected by us, and should only be replaced with matched

pairs. Please consult your Audio Note (UK) dealer should your

valves need replacing.

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Audio Note JINRO Specifications Page 13