Audio Note M10 Signature Specifications download pdf (Page 19)

OPERATION

Once all the connections are completed and checked, ensure that the volume

controls are at the minimum setting (rotated all the way left).

Ensure that all source components connected to the M10 Signature

preamplifier are switched ON. Source components should always be the FIRST

components to be switched on and the LAST components to be switched off.

Ensure that all power amplifiers connected to the M10 Signature preamplifier

are switched OFF. Any power amplifiers in use should be the LAST components to

be switched on, and the FIRST components to be switched off.

The above procedure minimizes the possibility of loud noises produced by

components at switch on being passed to the loudspeakers and possibly causing

damage.

Turn on the M10 Signature preamplifier by using the rocker switches located on the

rear panels of each Galahad Signature power supply unit above the mains inlet IEC

socket.

The M10 Signature preamplifier requires approximately 45 seconds to initialize

before it is ready for operation.

Input Selector Turn the selector to the source you wish to listen to.

Volume Controls There are two separate volume controls, one dedicated to

each channel. For a correctly produced Stereo or Mono

recording, adjust both channels to the same level. If it is

necessary to equalize the relative levels for each channel,

adjust the controls separately to achieve the desired balance.

1 2 ... 14 15 16 17 18 19 20 21 22 23

No comments

Audio Note M10 Signature Specifications Page 19