Audio-note M6 Phono User Manual download pdf (Page 11)

OPERATION

Once all the connections are completed and checked, ensure that the volume control

is at the minimum setting (rotated all the way left).

Ensure that all source components connected to the M6 Phono Pre Amplifier

are switched ON. Source components should always be the FIRST components to

be switched on and the LAST components to be switched off.

Ensure that all power amplifiers connected to the M6 Phono Pre Amplifier are

switched OFF. Any power amplifiers in use should be the LAST components to be

switched on, and the FIRST components to be switched off.

The above procedure minimizes the possibility of loud noises produced by

components at switch on being passed to the loudspeakers and possibly causing

damage.

Turn on the M6 Phono Pre Amplifier by using the rocker switch located on the rear

panel, above the mains inlet IEC socket.

The M6 Phono Pre Amplifier requires approximately 45 seconds to initialize before it

is ready for operation.

Input Selector Turn the selector to the source you wish to listen to.

Volume Controls There are two separate volume controls, one dedicated to

each channel. For a correctly produced Stereo or Mono

recording, adjust both channels to the same level. If it is

necessary to equalize the relative levels for each channel,

adjust the controls separately to achieve the desired balance.

1 2 ... 6 7 8 9 10 11 12 13 14 15

No comments

Audio-note M6 Phono User Manual Page 11